Stec Special ROM V0.2 Users Guide
MIDI Learn <go
back to table of contents>
The system also contains a learn mode for the following
controls:
Slap Time |
Slap Level |
Click Level |
Channel 1 Level |
Channel 2 Level |
Channel 3 Level |
Channel 4 Level |
Channel 1 Pan |
Channel 2 Pan |
Channel 3 Pan |
Channel 4 Pan |
You turn on the Learn Mode, select one of the previous parameters and
send the system MIDI. If you have something that generates controller data
on a single MIDI channel, you can very quickly connect up the JamMan to
the controllers.
Turn on Learn Mode
To turn on the Learn Mode, you hold down the STORE/LEARN (previously
FUNCTION) button. The system tells you it's in the Learn Mode by alternately
flashing
the letter "L". The mode is turned off by, again, holding the FUNCTION
button.
Select a parameter. Turn the mode knob to select one of the indictated
parameters. The slap and click are learned immediately.
The Channel and Pan take a bit more work.
-
Turn the MODE knob to "Channel"
-
Turn the SELECT knob to actually select the channel you want to program
(the "Channel" LED should be lit or flashing and the number displayed is
the selected "Channel". )
-
Turn the MODE knob to "Level"
-
Feed the system continuous controller data you want to assiciate with that
parameter.
-
Baste with a nice thick gravy and reduce heat
Disclaimer/Warning
Note that the learned controllers are only saved on power cycle if
you have the EEPROM memory backup installed.
If you don't have the EEPROM installed, it's probably best to use the default
values so you don't have to keep learning them each time the system
is power cycled.